Ford and Fordson

Ford 3000, 5000 and Commander 6000 Tractors

Ford 3000, 5000 and Commander 6000 tractors compared: build years, engines, serial numbers, loaders and what to check. Dates vary by source, so verify.

On this page
  1. Ford 3000: the 1965 to 1975 utility
  2. Charging system: generator or alternator
  3. Ford 5000: the larger utility with a diff lock
  4. Ford Commander 6000: the powershift row-crop
  5. Choosing among the three
  6. Safety on older Ford tractors
  7. What affects value

The Ford 3000, 5000 and Commander 6000 are mid-size Ford tractors from the 1960s and 1970s. They were built for different jobs, with different engines and transmissions, and their build years are reported differently from one source to another. This guide covers what each model was known for, how to date one, and what to check before you buy. Treat every figure as a reported value and confirm it against a reference for your exact tractor.

Ford 3000: the 1965 to 1975 utility

The Ford 3000 is a two-wheel-drive utility tractor, reported as built from 1965 to 1975. It has a three-cylinder engine, offered in two forms: a 2.6-liter (158 cubic inch) gasoline engine and a 2.9-liter (175 cubic inch) diesel. Published figures put the engine at roughly 47 horsepower, with about 38 horsepower at the PTO, though ratings vary by source and version.

Transmission options included 4-, 6-, 8- and 12-speed manual gearboxes, and a 10-speed Select-O-Speed. The rear PTO was rated at 540 rpm and could be transmission-driven or live. The three-point hitch is Category I, and the hydraulics were open-center at about 2,500 psi. The tractor weighs roughly 3,700 to 4,185 lb, depending on configuration.

How to find the year of a Ford 3000

The serial number is stamped on a metal casting near the starter. Reference data notes that a C prefix indicates a US build. Serial tables for the 3000 list starting numbers for each year from 1965 (C100000) through 1975. Use the table as a guide only, because the same serial starting points appear in tables for other Ford models of the same period. Confirm with a model-specific parts book or service manual before you rely on the year.

Charging system: generator or alternator

Many Ford 3000s were built with a generator and an external regulator, which can cause charging problems as the tractor ages. Reported specifications describe a 12-volt, 22-amp generator with a tachometer drive, and aftermarket replacements are sold for it. Check the belt tension, ground connections and wiring before you replace parts. A simple test is to measure the battery voltage at a higher engine speed, which should show a charging voltage above the battery’s resting level.

Some owners convert a generator setup to an alternator for more output and less maintenance. The tachometer drive can complicate this, so check the drive setup for your engine year before you start.

Ford 5000: the larger utility with a diff lock

The Ford 5000 is listed by one reference as built from 1968 to 1976. Another reference gives a serial table that starts in 1965 at C100000, which conflicts with that date range. Treat the build years as unsettled until you check a model-specific source.

Reported features include power steering, a mechanical rear differential lock, and wet disc brakes. The 5000 was offered in general-purpose and row-crop forms. Reported weights are about 5,740 lb for the general-purpose version and 6,250 lb for the row-crop version, with ballast bringing the total to about 9,700 lb.

The 772 loader is the loader most often listed for the 5000. Reported figures give it a lift capacity of about 2,500 lb at full height and a breakout force of about 4,000 lb.

Ford Commander 6000: the powershift row-crop

The Commander 6000 is a 1960s row-crop tractor built at Highland Park, Michigan. It came with a 10-speed Select-O-Speed powershift transmission, which lets the operator shift under load. Engines were a 4.0-liter six-cylinder diesel or a 3.7-liter six-cylinder gasoline or LP-gas unit.

Tested figures put the Commander 6000 at about 66.9 horsepower at the PTO and 61.7 at the drawbar. It had position and draft control, a Category II/I three-point hitch, and a Powr-Stor hydraulic accumulator system. One reference dates the original 6000 to 1961 through 1963. That version had reliability and transmission problems that led to a recall and updated models, so check which version you have before you buy parts.

Choosing among the three

  • Choose the 3000 for a smaller utility job, where a loader or light implements are the main need.
  • Choose the 5000 if you want power steering, a diff lock and a larger loader, and you can handle a heavier tractor.
  • Choose the Commander 6000 for row-crop work where a powershift transmission matters, and check the early and later versions carefully.

For older Ford models of similar size, see our Ford 2000, 2600 and 2310 guide. For the broader Ford model numbers that buyers often mix up, see the Ford Hundred Series article.

Safety on older Ford tractors

These tractors were built before modern safety standards, and some lack rollover protection. Check whether your tractor has a factory or aftermarket rollover protective structure, and use a seatbelt where the design allows. Keep PTO shields in place, disengage the PTO before dismounting, and use the differential lock only when needed, since it can cause wheel slip on turns. Test the brakes before you work on slopes.

What affects value

Value depends on engine version, transmission, cab, loader, running condition and originality. A tractor with a working loader and a documented history usually sells for more than a project of the same model. For a broader look at pricing, see what a Ford tractor is worth. For finding the serial number, see our guide to where to find the serial number on a Ford tractor.

The complete guide to ford and fordson

Ford Tractor Model Identification: A Year-by-Year Guide
Read the guide

Keep exploring

Guides from other topics

All topics →