Fordson is the name most often linked to Ford’s early tractors, and it causes confusion for owners today. The name covered a series of tractors built in several countries over almost half a century. Alongside those machines, Model T cars were turned into farm tractors with bolt-on kits. Both stories show how Ford’s farm machinery started and why the badge on a tractor does not always tell you everything.
The Model F and the 1917 launch
Production of the Fordson Model F began in October 1917 at Dearborn, Michigan. The Model F was built around a four-cylinder engine that could start on gasoline and then run on cheaper kerosene once warm. It used a frameless, or unit-frame, design, where the engine, transmission and rear axle housings bolt together to form the tractor’s structure. That design kept weight and cost down.
Early Fordsons reached farmers in the United States in 1918. They were part of a wider push to replace horses with machines on working farms. Many of the Model F’s features became common across later tractors.
Overseas production: Cork and Dagenham
Fordson tractors were also built overseas. Production in Cork, Ireland ran from 1919 to 1933. The line then moved to Dagenham, England, where it ran from 1933 until 1964. Machines from these factories can look similar to American-built Fordsons but may differ in details, so check the origin and the model before you buy parts.
The postwar Major and the Dexta
After the Second World War, the British line produced a range of larger and smaller tractors under the Fordson name. The Major was introduced in 1945, with later versions called the New Major, Power Major and Super Major. Later, the compact Dexta and Super Dexta arrived in the late 1950s and early 1960s. These are the models most often seen in Britain and Europe today.
When the Fordson name ended
Ford retired the Fordson name in 1964 and sold its North American and European tractors under the Ford badge. Machines built before that date can carry either badge. For identification, use the badge, the factory and the serial number together. Our guide to Ford tractor model identification explains the main clues.
Model T tractor conversions
The Model T was a car, not a tractor, but in the 1920s and during the Great Depression many farmers turned their Model Ts into work machines. Companies sold bolt-on conversion kits, including Pullford and a Sears kit sold through Peru Plow Works. The idea was simple: keep the car’s engine and put it to work in the field.
The Model T was built from 1908 to 1927, and its engine produced roughly 20 horsepower. That was enough for light farm work, but not for heavy plowing.
How a conversion worked
A conversion needed changes to the drivetrain and the wheels. Common changes included:
- Gear reduction. The Model T was built for road speed, so kits added a reduction unit to trade speed for pulling power.
- Reversed rear axle. Mechanics often turned the rear axle around so that the wheels turned in the right direction for forward travel.
- Steel wheels. Original wheels were replaced with heavy iron or steel wheels, often with cleats or lugs for better grip in soft soil.
- Belt pulley. Many setups added a front pulley to drive saws, grinders or threshers.
Limits and safety of Model T conversions
Model T conversions had clear limits. The engine’s cooling relied on thermosiphon circulation rather than a water pump, so it could overheat under heavy load. The light transmission, bearings and rear axle were not designed for long periods of heavy plowing, and parts could wear or break quickly.
Today these machines are mostly collector pieces. They have no rollover protection, and their brakes and steering are modest by modern standards. Anyone operating an original or restored conversion should treat it with caution, keep bystanders clear and check the drivetrain carefully before running it hard.
For the later N-Series, which replaced many of these early machines on Ford farms, see our Ford 9N restoration guide.