The Ford 335 is a Ford tractor, not a Ferguson or Massey Ferguson. There is no single horsepower figure to quote with confidence for every Ford 335. Published ratings depend on which version you have and how the power was measured. Use the figure in the spec sheet or manual that matches your tractor’s model and serial number.
Why horsepower figures differ
Tractor horsepower is usually given in three ways:
- Engine rating: the power the engine is rated to produce.
- PTO horsepower: the power available at the rear power take-off, which drives implements such as mowers and balers.
- Drawbar horsepower: the pulling power available at the drawbar, used for towing and tillage.
These are different measurements, and the numbers are rarely the same. PTO and drawbar figures are usually lower than the engine rating. Test conditions also differ. A figure from a sales brochure may not match one from a field test, so note where a number came from.
How to find the right figure for your Ford 335
- Read the plate. Note the model name and serial number from the tractor’s plate.
- Check the manual. The original operator’s manual or sales literature for that model is the most reliable source, since it was written for the machine.
- Use reference sites with care. Spec databases such as TractorData list figures by model and serial range. Compare them with the manual, because they can mix up different ratings.
- Ask owners. Owner forums often post measured figures for their own tractors. Treat these as one data point, not a rating.
- Confirm before you buy. If the number matters for a purchase or for matching an implement, have a dealer or specialist confirm it.
Matching implements to power
When sizing an implement, use PTO horsepower rather than the engine rating, because PTO horsepower is what drives most implements. For tillage and towing, drawbar figures matter more. Check the implement’s requirements against the figure that matches your tractor, and leave a margin for conditions such as heavy soil.
Ford and Ferguson history
Ford’s tractors and the Ferguson line share history. Ford built the 9N, 2N and 8N to Harry Ferguson’s three-point hitch design, but the Ford 335 is part of Ford’s own range. For the wider story, see Ferguson and Massey Ferguson tractors from the TE20 onward.