How Tractors Work

How Tractors Work: Parts of a Tractor and Their Functions

A tractor turns engine power into motion, sending it through the transmission, axles, and hydraulics. Here is what each part does and how they connect.

On this page
  1. What a tractor does
  2. Parts of a tractor and their functions
  3. The engine and fuel system
  4. Clutch and transmission
  5. Axles, differential, and final drive
  6. Steering and brakes
  7. PTO and hydraulics
  8. Hitch, drawbar, and electrical system
  9. How the systems work together
  10. How older tractors differ
  11. Safety basics
  12. Driverless tractors

What a tractor does

A tractor’s main job is to supply pulling force and power for other machines. It is a self-propelled vehicle built to pull or push implements such as plows, trailers, mowers, and balers. It also runs equipment through a rotating shaft and hydraulic lines.

In short, the engine makes power, the drivetrain sends it to the wheels or tracks, and the power take-off (PTO) and hydraulic system send it to implements. Each part has a specific job. On older machines, many of these parts are easier to see and reach.

Parts of a tractor and their functions

The table below lists the main parts and what each one does. Layouts vary by make, model, and year.

Part Function
Engine Burns fuel to produce rotating power
Fuel system Stores fuel and delivers it to the engine
Clutch Disconnects engine power from the transmission so you can shift gears
Transmission Offers gear ranges that trade speed for pulling force
Differential Lets the drive wheels turn at different speeds in a turn
Axles and final drive Carry the drive wheels and transfer power to them
Steering Turns the front wheels
Brakes Slow or stop the tractor
Power take-off (PTO) Drives implements through a rotating shaft
Hydraulic system Raises, lowers, and powers implements through pressurized fluid
Three-point hitch Attaches and lifts implements at the rear
Drawbar Tows trailers and wheeled implements
Electrical system Starts the engine and powers lights and gauges
Cooling and lubrication Keep the engine at a safe temperature and reduce wear

The engine and fuel system

The engine burns fuel inside its cylinders. The expanding gas pushes pistons down, and the pistons turn the crankshaft to provide rotating power.

Diesel engines ignite fuel by compression, without a spark. Petrol (gasoline) engines use a spark. On older machines, that spark often comes from a magneto rather than a battery-powered ignition. Most farm tractors today run on diesel, but many older and smaller tractors ran on petrol. For fuel choices, see do tractors take diesel or petrol?

The fuel system carries fuel from the tank through a filter to the injection system (diesel) or the carburetor (petrol). Clogged filters and dirty carburetors often cause rough running on older tractors.

The cooling system carries heat away from the engine, usually with coolant, a water pump, and a radiator. The lubrication system uses an oil pump and a filter to keep moving parts coated.

Clutch and transmission

The clutch connects the engine to the transmission. Pressing the clutch pedal disconnects the drive so you can change gears. Releasing it transfers power again.

The transmission trades speed for force. Low gears give more pulling force at lower speed, which suits plowing and heavy hauling. Higher gears suit faster travel. Some tractors use a hydrostatic transmission, which uses a hydraulic pump and motor instead of gear sets to give smooth, stepless speed control.

Axles, differential, and final drive

Power leaves the transmission and reaches the drive wheels through the rear axle housing. Inside it, a final drive reduces speed and transfers power to the axle shafts.

A differential sits between the drive wheels. When the tractor turns, the outside wheel covers more ground than the inside wheel. The differential lets the two wheels turn at different speeds.

An open differential sends power to whichever wheel has less grip. If one wheel slips in mud, it spins while the other gets little pulling power. A differential lock links the two axle shafts so they turn together for traction. Use it with care. The guide to tractor front axles and differentials explains when.

On a two-wheel-drive tractor, the front axle carries weight and steers. On four-wheel-drive or MFWD tractors, the front axle also drives the front wheels.

Steering and brakes

Steering turns the front wheels. Many older tractors use mechanical steering, where the steering wheel connects through a gearbox and linkage to the front wheels. Many newer tractors add hydraulic assistance to make steering lighter.

Brakes slow or stop the tractor, usually on the rear wheels. Many tractors have separate left and right brake pedals. Braking one rear wheel can help the tractor turn more tightly in small spaces, so use the pedals together and latch them for road travel.

PTO and hydraulics

The power take-off is a splined shaft at the rear of the tractor. It drives implements such as rotary mowers, balers, and tillers. Common PTO speeds are 540 and 1,000 rpm.

The hydraulic system uses a pump to draw fluid from a reservoir and push it through control valves to cylinders. On the three-point hitch, cylinders raise and lower the implement. Remote outlets let you run cylinders on trailers and other implements. On many tractors the hydraulic fluid is shared with the transmission and final drive, so check the manual before you choose a fluid.

Hitch, drawbar, and electrical system

The three-point hitch connects implements at the rear, lifts them, and transfers some of their weight to the drive wheels. The three-point hitch guide covers how it works.

The drawbar is a fixed bar at the rear for towing trailers and wheeled implements.

The electrical system starts the engine, runs lights and gauges, and charges the battery. Modern tractors usually use a starter motor and an alternator. Many older machines use a generator or a magneto, and some antique tractors were started by hand crank.

How the systems work together

Here is how the systems combine when a tractor pulls a plow across a field:

  1. The engine produces power, and the clutch and transmission select a gear for the work.
  2. The transmission sends power to the rear axle, where the differential and final drive turn the rear wheels.
  3. The three-point hitch carries the plow, and the plow’s weight adds to the rear wheels’ grip.
  4. The hydraulic system lifts the plow at the end of each pass, and the operator lowers it again to start the next one.

The front axle steers throughout, and the brakes and clutch are used as needed.

How older tractors differ

Older machines often show the same systems in a simpler form:

  • Many early tractors had no hydraulic lift. The three-point hitch and hydraulic lift became common later.
  • Mechanical steering and mechanical brakes are common on older designs.
  • Some antique tractors use magneto ignition and were started by hand crank.
  • Some older tractors have fuel systems set up for kerosene or distillate.

Check the operator’s manual or a service manual for your exact model. Specifications and layouts changed from year to year.

Safety basics

  • Keep PTO shields in place, and stay clear of spinning shafts.
  • Rollovers are a major cause of tractor injuries and deaths. Check whether your tractor has a rollover protective structure (ROPS), and use the seat belt where one is fitted. Many older tractors were built without a ROPS.
  • Before you work under a raised implement or the tractor, support it on stands, not just a jack.
  • Shut off the engine before you adjust or service moving parts.

Driverless tractors

Some newer tractors can operate with reduced or no onboard driver. They use GPS positioning and onboard sensors to control steering, speed, and implements. The power path is still the same: engine, transmission, drivetrain, and implement systems.

For more detail on individual systems, see the guides to tractor front axles and differentials, whether tractors take diesel or petrol, and how a three-point hitch works.

Keep exploring

Guides from other topics

All topics →