International Harvester

Farmall H: Specs, History and Value

Farmall H specs, history and buying notes: the 1939 two-plow row-crop tractor with a 152 cu in engine, plus the factors that shape its value today.

On this page
  1. Farmall H at a glance
  2. History
  3. Engine and drivetrain
  4. Buying and restoring
  5. Value
  6. Where to find specs and manuals

The Farmall H was a two-plow row-crop tractor that International Harvester built from 1939 into the early 1950s. Reference sources list its 2.5 L C-152 engine at about 26 hp belt and 24 hp drawbar, with a 5-speed sliding-gear transmission.

Farmall H at a glance

The figures below are as listed in reference sources. They can vary by year and configuration, so confirm them against your tractor’s manual.

Specification Figure
Production 1939 to about 1953
Engine C-152, four-cylinder, 2.5 L (152.1 cu in)
Power About 26.2 hp belt/PTO, 24.2 hp drawbar
Rated engine speed 1,650 rpm
Transmission 5-speed sliding gear, 1 reverse, dry disc clutch
Fuel Gasoline, distillate or kerosene
Weight About 3,875 lb
Wheelbase About 88.3 in
Length About 125 in
Standard width About 75.5 in
Height (to steering wheel) About 74 in
Fuel tank About 17.5 gal
Maximum drawbar pull About 3,600 lb

History

The H was part of the Farmall row-crop line. “Two-plow” describes the size of plow it was built to pull. It was built from 1939. Sources put the end of production around 1953 or 1954. Later models, including the Super H, followed it.

Engine and drivetrain

  • Engine: The C-152 is a liquid-cooled, four-cylinder engine that runs on gasoline, distillate or kerosene.
  • Hydraulics: The H used a Lift-All hydraulic system.
  • PTO: A 540 rpm rear PTO.
  • Drive: Two-wheel drive, with a standard narrow front tricycle.
  • Electrics: A 6-volt system with a generator. Sources list positive ground. Confirm the polarity in your manual before connecting a battery, charger or jump leads, since reversed polarity can damage electrical parts.

Buying and restoring

  • Confirm the model and year. Use the serial number and a production reference to confirm which H you have.
  • Use the manual for tune-up specs. Valve clearances, spark plug gaps and similar figures should come from the manual for your tractor, not from a general article.
  • Check the clutch and transmission. Look for slipping, hard shifting or unusual noise.
  • Check the hydraulics and PTO. Make sure the lift works and the PTO engages cleanly.
  • Keep original parts if originality matters. Original paint, decals and components affect value, so keep any parts you remove.

Value

Value depends on originality, condition, whether the tractor runs and drives, the quality of any restoration, the paperwork that comes with it, and any attachments. Compare recent listings and auction results rather than relying on a single asking price.

Where to find specs and manuals

  • TractorData and Machinery Pete both list Farmall H specs. Cross-check them with your manual.
  • Operator and service manuals are sold by reprint publishers. Check the serial range on a listing before you buy.

For the smaller Farmall, see Farmall Cub: Specs, History and Value.

The complete guide to international harvester

International Harvester and McCormick Tractors: A Collector's Guide
Read the guide

Keep exploring

Guides from other topics

All topics →